配资盘歡迎您的到来!

歡迎光臨慧投金融配资官網!【配资盘】材料生産,銷售和施工的高新技術企业.

    示例圖片三
    網站首頁 > 新聞资訊 > 新聞资訊

    配资盘表面縮孔産生的原因及解決辦法

    2019-06-04 13:54:01 慧投金融配资 閱讀

    優質的配资盘漆工程表面是整體無縫、光滑靓麗的,如果配资盘漆表面出現縮孔現象,就會使得光澤度受損,從而使得配资盘的美觀度和實用性大打折扣,而配资盘漆表面出現縮孔現象的原因有很多,隻有從根本上預防才能防止不必要的損失。下面光磊配资盘漆廠家就給大家詳細分析配资盘漆表面出現縮孔現象的原因及預防辦法。漆表面出現縮孔現象的原因:

    The engineering surface of high quality epoxy floor paint is seamless and smooth. If shrinkage occurs on the surface of epoxy floor paint, the glossiness will be damaged, which will greatly reduce the aesthetic and practicability of epoxy floor paint. There are many reasons for shrinkage on the surface of epoxy floor paint. Only by fundamental prevention can unnecessary loss be prevented. The following Guanglei floor paint manufacturers will give you a detailed analysis of the causes of shrinkage on the surface of epoxy floor paint and preventive measures. Reasons for shrinkage on the surface of epoxy floor paint:

    1、底層打磨不良可引起縮孔現象。

    1. Poor bottom grinding can cause shrinkage.

    2、基礎地面受到蠟或油脂等的污染同樣會造成漆塗膜縮孔。

    2. Foundation surface contaminated by wax or grease will also cause shrinkage of floor paint film.

    3、噴塗地坪漆施工時使用的壓縮空氣中,含有過量的水或油脂類物質也可以使漆塗膜出現縮孔的現象。

    3. In the compressed air used in spraying floor paint construction, excessive water or grease can also cause shrinkage of epoxy floor paint film.

    4、地坪漆施工現場受到污染(如有粉塵、水滴和油脂滴等),也可引起縮孔現象。

    4. The floor paint construction site is polluted (such as dust, water droplets and grease droplets) and can also cause shrinkage.

    5、配资盘漆幹燥成膜的的過程,如果表面溶劑揮發,表面聚合物的濃度增高,塗料黏度增高,都會導致表面張力和表面密度超過本體,形成凹陷,出現縮孔。

    5. During the drying process of epoxy floor paint, if the surface solvent evaporates, the concentration of surface polymer increases and the viscosity of the paint increases, the surface tension and surface density will exceed the bulk, forming depression and shrinkage.預防配资盘漆表面出現縮孔的方法:

    Method of preventing shrinkage on the surface of epoxy floor paint:

    1、底層打磨要均勻,同時要打磨充分,不能有漏磨的地方出現,然用細砂(高目數)紙全面均勻打磨一遍,并且把打磨産生的粉塵清理幹淨

    1. The bottom polishing should be uniform, and at the same time, the polishing should be sufficient, and there should be no leakage of wear. However, the fine sand (high mesh) paper should be used to polish the dust completely and evenly, and the dust produced by the polishing should be cleaned up.

    2、基礎地面上的油污要清除幹淨。

    2. Oil contamination on the ground should be cleaned up.

    3、徹底清理空氣壓縮機和導管、噴槍内的水分和油脂等。

    3. Clean up water and grease in air compressor and duct and spray gun thoroughly.

    4、要封閉施工現場,不能有灰塵。

    4. Close the construction site without dust.

    5、選用适應性強的地坪漆材料,嚴格檢測所選的地坪塗料成分。在地坪漆施工過程中也可以采用泡劑来預防表面縮孔,将其分散在地坪材料之中,減少不同塗料本身的低表面張力的流动性。

    5. Select suitable floor paint materials and strictly test the composition of the selected floor paint. Foam agent can also be used to prevent surface shrinkage during floor paint construction, disperse it in floor materials, and reduce the fluidity of low surface tension of different coatings themselves.配资盘漆表面出現縮孔解決辦法:

    Solutions to shrinkage on the surface of epoxy floor paint:

    如果配资盘漆表面已经出現了縮孔,可以先打磨一遍,清理幹淨後再滾塗一遍面漆。

    If shrinkage holes have appeared on the surface of epoxy floor paint, it can be polished first, cleaned up and then rolled over. 


    标簽:   配资盘 地坪 配资盘漆 配资盘施工 無錫配资盘
    無錫配资盘 技術支持: